Pur Bulk Melter는 어떻게 청소하고 유지해야합니까?

1. 청소할 때pur 벌크 멜터, the heating plate of the glue machine must be separated from the pur hot melt glue barrel, and all power supplies must be cut off while maintaining the pressure in the lifting cylinder. When the pur 벌크 멜터 is taking off the barrel, the air pressure should be increased slowly from small to large. It is not allowed to use high-pressure gas directly to take off the barrel, which is very dangerous and may cause accidents.

2. When cleaning the heating platen of the pur 벌크 멜터, you must wear special high-temperature protective clothing and high-temperature gloves. Do not let the skin contact the hot-melt adhesive barrel, molten pur hot-melt adhesive and heating plate and other high-temperature parts to avoid burns.

3. Pur bulkmelter가 배럴을 분리 할 때 배럴에 건조한 공기를 채우고 건조되지 않은 압축 공기를 직접 사용하지 말고 건조제 사용을 자주 확인해야합니다.

4. 퍼 벌크 용융 기가 핫멜트 접착제 배럴에서 분리 된 후 핫멜트 접착제 기계 압력판에 남아있는 퍼 벌크 접착제를 즉시 세척해야합니다. pur 핫멜트 접착제 기계 압력판을 청소할 때 단단한 도구를 사용할 수 없습니다. , 압력판의 긁힘을 방지하기 위해 Tefloncoating.

5. After the pressure plate of the pur 벌크 멜터 is cleaned, a small amount of silicone oil can be properly applied to the sealing ring of the pressure plate for lubrication, and then the pressure plate is immediately pressed into the new pur hot melt adhesive barrel to avoid the pressure plate being exposed for a long time. In the air. When pressing into the heating plate, the air pressure of the lifting cylinder should be from small to large, and high-pressure gas should not be used directly to prevent accidents and pay attention to the safety of operators.

6. When the heating platen of the pur 벌크 멜터 is pressed into the new rubber bucket, the overflow valve should be opened to completely discharge the residual air in the rubber bucket, and remove the pur hot melt adhesive with air bubbles to avoid The hot melt glue of air flows into the pump body and the throat of the hot melt glue machine. After the air is exhausted, the glue overflow valve is locked.

7. After changing the pur hot melt adhesive, you must wait for the machine to heat up for 20 minutes before starting the gear pump and motor. If the gear pump and motor are started immediately, the polyurethane gear pump will be damaged and the life of the pur 벌크 멜터 will be reduced.